Project: PolarYJ

nblehm · 04-18-2018, 03:12 PM

What I'm trying to figure out is, if I take a front hp60 and cut the inner c's off what kind of width that would leave me. From the rough internet measurements I could find I think I'd be pretty narrow at 56-57ish wms to wms. But the full floater spindles might help with that.

6DoF · 04-18-2018, 09:35 PM

Quote:

Originally Posted by nblehm

What I'm trying to figure out is, if I take a front hp60 and cut the inner c's off what kind of width that would leave me. From the rough internet measurements I could find I think I'd be pretty narrow at 56-57ish wms to wms. But the full floater spindles might help with that.

Yeah, that should yeild a really narrow axle with a huge pinion offset. Could be a good moon buggy axle.

nblehm · 04-19-2018, 12:17 AM

Quote:

Originally Posted by 6DoF

Yeah, that should yeild a really narrow axle with a huge pinion offset. Could be a good moon buggy axle.

Yeah, offset would be what I'm going for, would have to add long side tube though.

04-18-2018, 03:12 PM	#1
nblehm Needs moar dagger Join Date: Feb 2004 Posts: 26,809	What I'm trying to figure out is, if I take a front hp60 and cut the inner c's off what kind of width that would leave me. From the rough internet measurements I could find I think I'd be pretty narrow at 56-57ish wms to wms. But the full floater spindles might help with that.