Got another one! Project: PolarXJ

6DoF · 09-12-2023, 12:02 PM

my plan is to "polish" everything crusty with a wire knot wheel on a grinder ... anything that's TOO pitted i'll just replace while its' all apart. the one pc counter shaft looks all good, and i have all new bearings for the gears on the main shaft. the main shaft gears are only like $85 each worst case.

all things considered ... i'll probably just clean and send it. it'll work fine, only issue will be for how long. chances are long enough

09-12-2023, 12:02 PM	#11
6DoF AKA: jeepnski Join Date: Sep 2002 Location: Pittsburgh, PA Posts: 17,138	my plan is to "polish" everything crusty with a wire knot wheel on a grinder ... anything that's TOO pitted i'll just replace while its' all apart. the one pc counter shaft looks all good, and i have all new bearings for the gears on the main shaft. the main shaft gears are only like $85 each worst case. all things considered ... i'll probably just clean and send it. it'll work fine, only issue will be for how long. chances are long enough __________________ ...................................___ .................. ________\|\|___\____ ..;.;;.:;:;.,;..;\|/_(O)\______ /_(O)\|

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode