[6DoF]

this air line routing feels stupid, but is what the directions, and Eric said to do. also managed to get this bulkhead fitting in without stripping it this time, haha.

then the MOSER shafts came in and one was long, good thing they had extra splines cuz my custom length shafts had to be cut down by .75". got a nice little slug for my desk at work now.

cut up the old rear drive shaft and added an inch for the new front. sleeved inside with the plug welds. she'll last more than long enough to work out all the details to order good new shafts. for a 2pc drive shaft and a stock axle pinion support, that's not a bad angle.

then, du da DA! she lives!!! still needs shock mounts to be trail ready, and eventually a real air system. of course i still have a full list of future plans