Thread
:
'55 Chevy 3800 Cummins
View Single Post
10-29-2021, 06:56 AM
#
245
6DoF
AKA:
jeepnski
Join Date: Sep 2002
Location: Pittsburgh, PA
Posts: 16,548
BOOM! DONE!
i mean, as done as it's going to be until after assembly. the chassis is still missing f/r bumper mounts and rear hitch receiver. things that i need the bed on to get a complete look at to know where they go. to this point i've only confirmed that i'm pretty sure the bed will somehow fit if i cut some things up a bit, haha.
the big add last night was the Zip-Tie tabs, 39 in total. i had 31 welded to the chassis before i thought ... "i should check and make sure a ziptie fits in these". also kind of detailed out the other bits in prep for paint. one more fancy plate got holes drilled, and the LCA's got drain/rock escape holes on the back edge of the bag pockets. front edge will still push gravel if needed, but the back i wanted stuff to be able to get out.
__________________
...................................___
.................. ________||___\____
..;.;;.:;:;.,;..;|/_(O)\______ /_(O)|
6DoF
View Public Profile
Send a private message to 6DoF
Find More Posts by 6DoF