so i'll be really disappointed if i never get the chance to throw way too many PSI's at this motor. with that in mind, and my current record of blowing out drive shafts, i wanted to make sure i gave this every chance to live. enter the 1410 series u-joints, ram used them factory on some HD applications and is what the truck-pull guys will upgrade to as well.
i need a 2pc drive shaft just for length alone, and to get out from under the cab easier. i also wanted a CV rear shaft with the CV flange fixed right at the truck arm pivot. this would give me the "perfect" shaft angle thru the entire range of travel. this all meant that i needed a fixed carrier bearing at a different angle than the forward shaft, really you could maybe call this a 3pc drive shaft. the carrier bearing or mid shaft, will be at the same 6.5deg as the transmission and have a standard shaft between the trans to bearing. the bearing will be fixed to the chassis and give me the fixed CV flange output to the axle.
so Branik Motorsports sells this ultimate carrier bearing for KOH rigs. however they only sell it with a standard yoke on both ends. Dodge used a 1410 CV in the front of some 4x4 trucks, and dimensionally i figured it could be used in the assembly. i bought a used yoke, mailed it to Branik, and they machined it to work! 32spline chromoly shaft, shimmed bearing pre-load, and ready to weld in. can't weld it with the bearings in there, so once it's fit i'll pack it with grease and install the seals.
