[Sir Sam]

old post quoted:

Originally Posted by Sir Sam

Ok, did a little bit of teardown and started looking at what it would take to get this 2500 header panel to fit.


So as you can see the 2500 header fits back in a little bit:

I measure 3.25" deep:

And I measure 3.25" back from the leading edge of the hood. So basically the header is supposed to sit back flush against the front face of the "headlight bucket" so it looks like I will be trimming off that whole side piece where the fender bracket ties the fender to the "headlight bucket" with the ~.25" gap between the header panel and the hood I think that will be just about right.

And semi naked: