No special tools. I don’t use hog rings but I do use small zip ties and flush cutters.
Take seat out 3x13 mm bolt 1x18mm nut. Drivers side has seat belt sensor plug.
Remove plastic trim 3x Phillips.
Unbolt upper section, 2 x 13mm on recline lever side. 1x13mm on trans tunnel side or T40. Keep plastic spacer between seat parts on the bolt. You’ll see what I mean, don’t lose it.
Flip base upside down and remove plastic groove holder from front, inside and carpet. Two fir tree style release clips on vinyl side.
Use pliers to twist and break hog rings.
Upper portion is easy since you don’t need to pull cover off just open at the bottom and slide the heater up.
|