[Sir Sam]

old post quoted:

Originally Posted by Sir Sam

So I picked this up for my MJ CRD project, I need it for a few different things, but since I had it out I decided to take the whole shebang apart! While I was at it I decided to bust out the macro, never really played with it before but I liked the results.




This is the keyless module, it plugs into the side of the BCM, and can be removed pretty easily.



This is the BCM its self, it is held on by 4 screws onto the fuse box/junction block.










This is the gut of the junction block, when you take out all the fuses, relays, etc, remove the plastic cover, this is what you are left with:










The BCM is needed as the VSS signal goes into the BCM, where the BCM is programmed to read the VSS and correlates the revs/mile to the speed. A couple of other things also got through the BCM including the SKIM info(which I won't be using).