11-04-2017, 01:43 PM
|
#27
|
Working Mother
Join Date: Mar 2004
Posts: 19,883
|
old post quoted:
Quote:
Originally Posted by Sir Sam
Got the steering column bracket in place, modded it to accept one of the existing studs and then welded one from the donor vehicle in place on the side.
Then I got the lower pivot hole welded in, cut off the factory nut from the donor then drilled a hole and welded the plate in. Still need to do the passenger side.
As you can see here two of the upper dash bolt holes don't line up, I think I'm going to weld a tab to the existing smaller lip and then drill a hole and move the threaded clip in place, then just use a large washer on the small bolt, this needs to be done on both sides.
|
|
|
|