Had one more day off work. And actually did some work on the waggy.
Lower control arm mounts are tacked in. I might slide the front axle back just a hair for better fender clearance up front. Waiting on upper control arms, bushings and mounts. Picked up newer JL Take off springs front and rear, lower control arms and track bar. Also tonight got some 392 fox shocks for cheap with only 5k miles on them. Can’t remember if I stated this but trying to use as many stock Jeep parts as possible. Everything is lining up really nice. Hopefully the rest of the parts I ordered will be here by next weekend so I can get the front close to on its own weight. Then I can do exhaust, finish the wiring and move onto the rear axle swap.
Used some leftover lower control arm mounts I had
Track bar looks like it should work great. Might have to move the coil buckets out a little bit.
Hoping this is about ride height. Measured to the back would be about 4” of lift. Tires are 32s
New shocks
