i've not been able to find a formed silicone gasket for the 12v unfortunately ... if i ever do another paper pan gasket like this, it'll be heavy glue to the pan and greased to the block.
if i have to mess with this one again, i'll slightly loosen the pan bolts on that side, brake clean down the pan/block rails and gasket edge, pack RTV in there like a wheel bearing, then re-torque after cure.
this morning there was still zero on the floor again. it either will only drip while running, or i got it sealed with the re-torque
__________________
...................................___
.................. ________||___\____
..;.;;.:;:;.,;..;|/_(O)\______ /_(O)|
|