Jeepin.com Forums - View Single Post

6DoF · 10-02-2023, 07:13 AM

that was seriously satisfying to use. 3D printed drill jig, alignment pins printed in that snuggly fit into the current pattern, and printed holes that i tapped for steel thread-in drill guides. factory is a 10deg difference, i made the jig 12deg up or down. so this TJ trans now has a pattern 2deg lower than factory XJ to help with front drive shaft angles, but is still well over top the crossmember. the other pattern would let a TJ owner take an XJ trans and drill it 2deg flatter than factory for more skid clearance.

I'll probably never use it again, but now i have it! ... i need to get it posted on thingiverse

10-02-2023, 07:13 AM	#239
6DoF AKA: jeepnski Join Date: Sep 2002 Location: Pittsburgh, PA Posts: 17,134	that was seriously satisfying to use. 3D printed drill jig, alignment pins printed in that snuggly fit into the current pattern, and printed holes that i tapped for steel thread-in drill guides. factory is a 10deg difference, i made the jig 12deg up or down. so this TJ trans now has a pattern 2deg lower than factory XJ to help with front drive shaft angles, but is still well over top the crossmember. the other pattern would let a TJ owner take an XJ trans and drill it 2deg flatter than factory for more skid clearance. I'll probably never use it again, but now i have it! ... i need to get it posted on thingiverse __________________ ...................................___ .................. ________\|\|___\____ ..;.;;.:;:;.,;..;\|/_(O)\______ /_(O)\|