Thread
:
'55 Chevy 3800 Cummins
View Single Post
06-14-2021, 07:20 AM
#
204
6DoF
AKA:
jeepnski
Join Date: Sep 2002
Location: Pittsburgh, PA
Posts: 16,751
so after a little more trim/eyeball/trim/eyeball/over-trim ... the filler plate went in. you can also see where i extended the floor cut towards the tunnel for more bad metal along the entire factory seam. then more prep involving dry time, so i filled the holes in the rear floor, that officially go crossed off the list! and back to toiling away getting the mount structure to actually line up with the mount location. notice the slot, it was way off.
the entire cab is assembled with overlap fits and i personally think they are stronger and line up the panels better, so i went with that. it's also worked really well for floor pans in a few jeeps before. and success! holds it's own weight, rocker is level with the ground still, and i won't be flintstoneing it any time soon!
__________________
...................................___
.................. ________||___\____
..;.;;.:;:;.,;..;|/_(O)\______ /_(O)|
6DoF
View Public Profile
Send a private message to 6DoF
Find More Posts by 6DoF