home from NC ... but going back next week. i had to miss the wheelin trip i had planned, and kinda dragged this wrap-up out a little bit.
dug into shocks finally. figured out all the new mounts n lengths, going to use the same Bilstien 5125's front and rear. also sticking with the 90s Ford f350 upper mounts, but cutting them down a bunch. rear will get out-boarded and half frenched into the frame now. steering needs a little frame notch, after wiggling the jeep around it settled down and touched. i'll also cut the misalignment spacers down by 1/4" without effecting their travel.
while looking at it all and only doing this once as a final solution, i decided to cut off the rear frame spring hangers like i did the front for HD hangers. will also be moving them back another 1" for a new total rear stretch of 4". the rear DS i have in it is on the long side, so no need to even change it.