[6DoF]

Originally Posted by Cobound

As with anything, you pay for their precise bends, quality, etc, etc. Yeah, I can't justify that cost, I'd just go have someone local make it, if that was the case. Of course, this would take less time, go where it's supposed to, you know the drill.

Also, to tie into the frame, there are very few that do, that I'm aware. Yes, while that would be ideal, these cages hold up to what it is people are using them for.

agreed ... that's why the TJ isn't tied in. it very well might be at some point, but that's a much later project.